Airsoft rifle Amoeba AM-015 - desert

One of the latest M4 Amoeba Airsoft series with many interesting technical and design solutions.

The first aspect that draws attention is the size of the weapon. The small proportions make the weapon very suitable for CQB, where the maneuvreability is vital and for drivers.

The replica's receiver, buttstock and sights was made of strengthened nylon. Quality is so good that it can hardly be recognized whether it is plastic or metal. Metal was used to produced the outer barrel, the flash hider (14mm CW thread), the stock tube and some small pieces. The pistol grip is made of plastic, covered with scrabrous non-slip texture which improves grip and comfort. Interesting is the magazine release, which is enlarged - you will appreciate it by magazine quick-change. By pulling the double-sided bolt lever, the dust cap is opened and allowing access to the hop-up system control.
The replica has the tube-buttstock and it is suitable for small Li-Po 7,4V battery (recommended voltage is max 9,6V, higher battery voltage can cause damage to internal parts).Tip: If you need to extend the battery compartment, we have an extension in our offer, find it under the code 7734 and 7735. It is adjustable to two positions for a better fit. RIS rail on the upper side of the replica is devided, on the hand guard, there is another RIS rail attached. You can attach a grip to it, however, a quality compact grip is included.
A mid-cap magazine for 120BB is included. Its specific feature is in the PMAG pad for rapid pulling out of the magazine pouch and the non-slip texture on the surface of the magazine.

ECFS gearbox

Internally, this replica is among the most advanced airsoft weapons on the market. Metal gearbox with 8mm bearings and reinforced parts, quick-change spring (no need to disassamble the weapon, just remove the stock tube), powerful engine and last but not least the Electronic Firing Control System (EFCS). It is an electronic unit with MOSFET that prevents contact tanning, protects the battery, and makes it easy to set your shooting mode (Safe / Semi / 3rd burst / Auto). The EFCS setup is done by the Ares electronic programmer, which is found in "Related products" below.