Transformers AUTOBOT Hop Bucking 70° for VSR and GBB

The new line of Hop-Up buckings Transformers Autobot from the manufacturer Maple Leaf, which is based on the very popular Autobot series buckings. Compared to the previous series, this bucking has two smaller protrusions on the sides of the main pressure protrusion, as in the Super series bucking. These protrusions are in touch with the edges of the cut-out window in the barrel and thus ensure better sealing, support and stabilization of the bucking. In addition, the material and its composition was modified here, so the bucking works better at a lower temperatures.

The bucking is the VSR type, ie for sniper rifles and gas guns. The special shape of the protrusion (Diamond), which is pressed into the barrel, increases accuracy and especially the range. The package includes a metal ring, which, when installed on the bucking, further increases the seal. However, its use is not a condition. The rubber is suitable for Marui VSR manual rifles and their copies and Marui / KJ / WE GBB gas weapons. Before buying, make sure that the hardness of the bucking suits to you. See table below.

• 50° for guns with the output velocity bellow 110 m/s (360 FPS)
• 60° for guns with the output velocity 90 - 120m/s (295 - 400 FPS)
• 70° for guns with the output velocity 110 - 140 m/s (360 - 460 FPS)
• 75° for guns with the output velocity 130 - 150 m/s (430 - 500 FPS)
• 80° for guns with the output velocity above 150 m/s (500 FPS)

Notice
For the proper operation of the hop-up rubber, the barrel must not have a bridge at the hole for the nub.