Airsoft rifle Amoeba AM-016 - black

One of the latest M4 Amoeba Airsoft series with many interesting technical and design solutions.

The replica's receiver, buttstock and sights was made of strengthened nylon. Quality is so good that it can hardly be recognized whether it is plastic or metal. Metal was used to produced the outer barrel, the flash hider (14mm CW thread), the stock tube and some small pieces.
The metal handguard is original Octarms Ares with Keymod system. KeyMod sections are located at the 3, 6 and 9 o’clock position. The rail is mounted to the upper receiver with 6 hex screws. The barrel freely passes through the hand guard and ends with a flame hider. The “Octarms” KeyMod rail is CNC-machined out of 6063 aluminum alloy and very lightweight. It is made of one piece, which increases the durability of the hand guard.
The pistol grip is made of plastic, covered with scrabrous non-slip texture which improves grip and comfort. Interesting is the magazine release, which is enlarged - you will appreciate it by magazine quick-change. By pulling the double-sided bolt lever, the dust cap is opened and allowing access to the hop-up system control.
The replica has the tube-buttstock and it is suitable for small Li-Po 7,4V battery (recommended voltage is max 9,6V, higher battery voltage can cause damage to internal parts). It is adjustable to four position for a better fit.
Hi-cap magazine for 300BB. Its interest is the PMAG pad for rapid pulling out of the magazine pouch, non-slip texture on the surface of the magazine and visually appealing transparent gaps on shells.

ECFS gearbox

Internally, this replica is among the most advanced airsoft weapons on the market. Metal gearbox with 8mm bearings and reinforced parts, quick-change spring (no need to disassamble the weapon, just remove the stock tube), powerful engine and last but not least the Electronic Firing Control System (EFCS). It is an electronic unit with MOSFET that prevents contact tanning, protects the battery, and makes it easy to set your shooting mode (Safe / Semi / 3rd burst / Auto). The EFCS setup is done by the Ares electronic programmer, which is found in "Related products" below.