Max Flow - HPA Low pressure regulator

Low pressure HPA regulator MaxFlow by Czech company EPeS.

The MaxFlow HPA regulator can be used with any standard paintball HPA tank. The recommended input for the MaxFlow regulator (or the tank regulator output pressure) is 850 PSI. The regulator can work even with lower input pressure, but full and correct operation cannot be guaranteed. Do not use input pressure higher than 900 PSI.

The on/off and the pressure setting function is performed using an Allen screw located in the head of the regulator. By slowly screwing the Allen screw clockwise, the tank is opened and then the output pressure of the MaxFlow LP regulator starts to increase gradually. The regulator operates in the output pressure range of 0–225 PSI.

MaxFlow is equipped with an adjustable safety valve. To adjust it, unscrew the red cover nut counterclockwise. There is a setting screw under the red nut. Turning the screw clockwise increases the pressure limit at which the safety valve starts releasing the pressure.

Once the desired pressure has been set, the regulator can be locked to prevent the change in the output pressure settings. MaxFlow allows several ways of locking to be used.

1. Destructive sticker - with a unique number. This sticker can be used to seal the hole containing the setting screw, making it impossible to manipulate the setting screw without destroying the sticker. The event organizer will only note down the unique number of the sticker corresponding to the unique player. Destructive stickers are included in the package. Replacement destructive stickers can be purchased from our online store or from our partners.
2. Plastic cable ties - after locking the adjusting screw with a small Allen screw in the groove of the regulator's head, the locking Allen screw can be covered with a plastic cable tie, which is commonly used by the event organizers. Without cutting the tie, the locking Allen screw cannot be loosened and the pressure setting cannot be changed using the large setting screw.
3. Standard Tournament Lock - the cap which is put on the head of the regulator and secured against removal by plastic cable ties. These caps can be printed on a 3D printer and the print file is available here - free of charge.

Max Flow is not designed for CO2.

Please read the instructions before use, see the Documents tab.

Package contents

• MaxFlow HPA Low-Pressure Regulator
• 2 destructive stickers
• 2 Allen keys
• replacement piston o-ring
• long pressure setting screw
• instructions manual