Digital programming card SLC for Solink V5 brushless motors

Developed specifically for V5 engines, the SLC Lite digital programming card can set the motor speed (or torque) in 1,000 rpm increments and also provides a battery monitoring function.

The motor speed can be set between 10k and 46k rpm in 1k rpm increments using this digital programming card (default: 46k rpm, 11.1V). The digital programming card only works with the Solink V5 brushless motor. It is not applicable for other models or other brands of motors.

The motor speed can be adjusted by changing the current - default value: 60%.

The programming card has a Li-Po battery tester function. Just connect the battery to the card using the balance connector on the top of the card. For connecting the battery, the card has an XT30 connector. XT30-DeanT adapter is included.

Description of buttons

• "M" Short press to select the item you want to set, long press to reactivate the card if it was previously disconnected.
• "-" Short press to decrease the value of the selected item, long press to quickly decrease the value of the selected item.
• "+" Short press to increase the value of the selected item, long press to quickly increase the value of the selected item.
• "S" Long press to save the setting to the motor.

Safety warning

• Some malfunctions, poor contact, or unexpected situations may cause the motor to rotate unexpectedly. Therefore, the motor must be securely fixed before using this product.
• The motor must be securely connected to the setup card cable before turning on the setup card, otherwise accidental motor spinning may occur.
• The voltage of the battery used to power the setup card must be higher than 7.4 V, otherwise unexpected motor spinning may occur.
• After saving the settings, the programming card will disconnect itself and disconnect from the motor. To make further settings, you must turn it back on or press and hold the M button to reconnect it.
• Do not disconnect the motor leads while moving through the setup menu, or unexpected motor rotation may occur.
• If the maximum rated ETU current is less than the defined motor starting current, we are not responsible for any damage this may cause.