Programmable MOSFET Burst with active brake Ver. 4a

Smart electronic circuit BURST, which simply allows programming of the AUTO mode of AEG.

The main advantage of the Burst Ver 4a is easy programming of the burst on any AEG gun. Just connect the mosfet between the gun and the battery and use the trigger to set the AUTO mode selector switch. The device responds audibly as you set it. One pull of the trigger can be set to fire a pre-programmed number of BBs - 3 / 6 / 9 / 12 shots.

• Burst function - firing predetermined BBs per trigger pull (3 / 6 / 9 / 12 shots), default is 3 shots.
• Built-in Mosfet circuit (but due to the wiring it does not prevent scorching of the contacts).
• Small dimensions: 43 x 17 x 7 mm.
• User-friendly control - everything is programmed with just a press of the trigger.
• Very easy to install - just connect between the gun and the battery.
• No soldering.
• Low battery detection.

Programming

• Pull the trigger and hold until 1 beep sounds.
• Continue to hold the trigger until the next beeps sound (depending on the set mode): 3 rounds - 1 beep, 6 rounds - 2 beeps, 9 rounds - 3 beeps, 12 rounds - 4 beeps
• Release the trigger
• Pull the trigger according to the desired setting: 1x 3 rounds, 2x 6 rounds, 3x 9 rounds, 4x 12 rounds
• Release the trigger, pull again and hold until 3 beeps sound
• Release trigger - settings are saved

Specifications

• Operating voltage: 7,2 - 11,1 V
• Maximum continuos current: 65 A
• Operating temperature: -10 °C up to 70 °C
• Suitable for batteries: NiMH 7-10 cells, Li-Po 2-3 cells
• Low battery detection: 6,6 V and 9,9 V