Low Ride Duty Drop - Olive Drab

HEIGHT ADJUSTMENT

3 pairs of screw holes on the front pad are used for carrying height adjusment. Simply use the M4 (smaller) Allen Key to complete the adjustment.

1. Remove the pair of the screws. Notice to keep the screws and nuts.
2. Move the connection panel to another pair of screw holes.
3. Put back the screws and nuts to complete adjustment.

ADJUSTMENT BELT LEVER

There is a lever at the back of the pad. It’s used to ajust the space of the loop. It supports 1.5” – 2.5” belts. You may need to remove the lever if you wear a 2.5” belt.

1. Push the lever to remove it
2. Check your belt width
3. Stuck the lever in the proper holes to complete the adjustment

360 DEGREES ROTATION

Holster body and carrying platform are connected with a tooth gear. The holster body is 360 degrees rotation. User can easily adjust the carrying position.

Steps to adjust the carrying position:

1. Slightly loosen the screw by Allen key (included) through the front hole
2. Adjust a preferred angle
3. Tighten the screw by Allen key through the front hole