Li-Po battery 14.8V 2300mAh 75C 105x35x29mm - XT60

Tattu Li-Po battery with a capacity of 2300 mAh, voltage of 14.8 V and 75C discharge rate. The 4S1P configuration is suitable especially for FPV racing quadcopters, RC models and other applications requiring high discharge performance.

The battery is equipped with an XT60 connector and 14 AWG wires. The cells are protected by a soft case with heat-shrink wrapping.

Specifications:
- Manufacturer: Tattu (Gens Ace / Genspow)
- Type: Li-Po
- Capacity: 2300 mAh
- Voltage: 14.8 V
- Configuration: 4S1P
- Discharge rate: 75C
- Charge rate: up to 2C
- Connector: XT60
- Wire gauge: 14 AWG
- Dimensions: 105 × 35 × 29 mm
- Weight: 270 g
- Case: soft case
- Manufacturer code: TA-75C-2300-4S1P-XT60

IMPORTANT USAGE WARNING

This battery is intended only for WELL M249 -S machine guns when used with a suitable XT60 to Dean-T adapter (product code 18639). Not suitable for the Para version. It will not fit.

Using this 14.8V (4S) battery in other standard airsoft guns is highly risky and may damage the internal gears and other gearbox components. We therefore strongly advise against using it in other airsoft guns.

To extend the life of your Li-Po battery

• Never fully discharge the battery.
• Stop using the battery as soon as the rate of fire or performance decreases.
• Charge the battery before storage (Storage mode).
• IMPORTANT: always use a Li-Po charger with a balancer.

WARNING

Use only high-quality Li-Po chargers and never use a NiMH or NiCd charger to charge Li-Po batteries.

• Do not puncture the battery.
• Do not disassemble the battery.
• Do not short-circuit the battery.
• Do not connect the battery directly to an electrical outlet.
• Do not throw or drop the battery onto hard surfaces.
• Do not immerse the battery in water.
• After use, charging or discharging, always disconnect the battery immediately and store it in a cool, dry environment.
• Do not use or leave the battery near a heat source such as fire or a heater.
• Do not dispose of the battery in fire.
• The battery should not be charged at a rate higher than 1C. For a battery with a capacity of 2800 mAh, 1C corresponds to a charging current of 2.8 A. Charging at higher currents may damage the battery cells or lead to overheating or other serious failures.
• If the temperature exceeds 45 °C, stop charging immediately.
• Stop using the battery if the temperature exceeds 60 °C. Never leave Li-Po batteries charging unattended.
• Always monitor the Li-Po battery charging process so that you can react immediately to any problems.
• If the Li-Po battery begins to swell or puff up, stop charging, discharging and using it.
• Inspect the battery before and after use for physical damage or swelling, as these are signs of possible battery failure.
• Before use, read all instructions on the battery, box and packaging. We recommend using a protective Li-Po safety bag when charging Li-Po batteries.
• Always use a charger designed for Li-Po batteries when charging Li-Po batteries.
• Do not overcharge the battery. The maximum voltage per cell is 4.2 V.
• Never fully discharge a Li-Po battery. If the voltage drops below 3.2 V per cell, permanent battery damage may occur (not covered by warranty). As soon as you notice a decrease in performance or rate of fire, stop using the battery immediately.