Airgun DAN WESSON 6" CO2, cal. 4.5mm (.177) - Silver

Airgun calibre 4,5 mm designed for target shooting. The weapon uses pellets or BBs as ammunition. It is not an airsoft replica.

Dan Wesson guns bear the name of their founder Daniel B. Wesson II, the great-grandson of the original Daniel B. Wesson, who was a co-founder of the famous gun manufacturer Smith & Wesson.

The Real Steal Model 44 revolver, originally introduced in the 1980s, was made primarily with a 6-inch barrel - but there were multiple barrel length variations. It was developed for target shooting and hunting. When you say Dan Wesson, most people think of the company's legendary Model 44 double-action revolvers like this one.

A very faithful, full metal replica of a real-steel DAN WESSON 6" revolver with all the details, including the speed loader with cartridges.

The guns are manufactured under a purchased Dan Wesson license and each bears the name of Daniel B. Wesson, co-founder of Smith & Wesson. It has authentic markings and an individual serial number stamped into the frame.

The Dan Wesson revolver is made of metal except for the ergonomic grip made of hard ABS plastic with the DW logo. The grip houses a 12g CO2 cartridge which is easily accessible by sliding the grip backwards. The cartridge is tightened by an integrated key on the underside of the grip. Simply insert the cartridge, tighten the screw, slide the grip back in and you are ready to fire. The cartridge will last approximately 50 shots.

The revolver is equipped with a double-action trigger, i.e. one pull of the trigger turns the cylinder, pulls the hammer and fires. For more accurate shooting, the hammer can be cocked separately and only the trigger pulled to fire. In this case, the trigger travel is significantly shorter and smoother and the risk of "pulling" the gun sideways when firing is reduced.

The cylinder is made from a single piece of metal, adding to the overall solid feel of the revolver. To change cartridges, simply slide the button behind the cylinder and tilt the cylinder to the side. The button also serves as a manual trigger safety (by sliding it back). Of course, there is also a cartridge ejector - a rod in the axis of the cylinder that, when pressed, lifts the cartridges out of the cylinder.

Reloading is very easy and fast thanks to the included speed loader. You insert one 4.5mm BB into each cartridge, slide the cartridges into the speedloader, squeeze the speedloader holder and rotate it to the right. This secures the cartridge against falling out. After that, all you have to do is insert the cartridges into the cylinder and lightly press. The spring is released and the loader almost shoots the cartridges into the cylinder.

The revolver has an 11mm Weaver rail on the top and an adjustable rear sight for greater realism and accuracy.

It is possible to purchase 4.5mm pellet cartridges and Moon clip cartridges/set for the revolver.

The revolver comes with a speed loader, 6 cm RIS rail for red-dot installation and 6 pcs of 4.5 mm cartridges. The rail attaches to the top frame - first you remove the rear sight, then slide the RIS rail on, secure with a worm and put the rear sight back on.

Package contents

• revolver
• speed loader
• 6 cartridges
• RIS rail 6 cm
• allen key for tightening the RIS rail

Note

CO2 cartridges are disposable, non-refillable. It is necessary to empty (shoot) the cartridge before removing and not leave it unnecessarily pressurized in the gun - it will degrade the seal. We recommend using one CO2 cartridge with silicone oil after each approx. 10. cartridges. This will extend the life of the gun.

If you are ordering an airgun to a country other than the Czech Republic, check the legislation in your country - what are the conditions for acquiring, possessing and firing a gun.