Compact weapon light GL19R

The Fenix GL19R rechargeable LED pistol flashlight is designed specifically for use on short guns equipped with MIL-STD-1913 and Glock Picatinny rail.

It offers a maximum light output of 1200 lumens with a range of up to 210 meters. The flashlight is powered by a single Fenix ARB-L18-1100P Li-ion battery (size 18350), which charges via a USB-C connector directly in the flashlight (battery and cable included).

Simplified flashlight control is ambidextrous (for right and left-handed users). Mounting on the weapon rail is easy and requires no tools - the flashlight slides onto the weapon rail and secures with a lever. The flashlight can be mounted on Picatinny MIL-STD-1913 and GLOCK standard weapon rails. The flashlight is suitable for professionals, sport and hobby shooters and airsoft.

The flashlight has an intelligent overheating protection. Due to the high power in 1200 lumens mode, there is no heating of the flashlight. If the internal temperature of the flashlight rises to 60°C, it will automatically start to reduce the power. As soon as the temperature of the flashlight drops below 60°C, the power will gradually increase again.

All flashlight parameters (luminous flux, battery life, waterproofness, range and shock resistance) are measured in accordance with ANSI/NEMA FL 1-2009.

TECHNICAL SPECIFICATIONS

• Premium LED Luminus SFT-40 with 50 000 hours lifetime.
• Three lighting modes: 1200 lumens / 11000 cd / 210 m (1 hour) -> 350 lumens / 3000 cd / 110 m (2 hours) -> 1200 lumen strobe.
• TIR optics produce a light cone with a range of 210 m (11,000 cd).
• Reverse battery insertion protection and protection against too deep battery discharge.
• Powered by one Fenix ARB-L18-1100P type 18350 Li-ion battery (included).
• Charging via USB-C connector with battery charge status indication.
• Compatible with Picatinny MIL-STD-1913 and GLOCK standard weapon rails.
• Flashlight has memory and always turns on in the last set light mode (1200 or 350 lumens).
• Intelligent overheat protection.
• Flashlight body made of aerospace hardened aluminum.
• Durable hard scratch resistant surface - Type III hard anodized.
• Shockproof against falls from a height of 1 meter.
• Highly wear-resistant, flat-running threads.
• Waterproof and dustproof to IP68 standard (tested underwater at 2 metres for 30 minutes).
• Dimensions: 7.7 cm (length) x 3.4 cm (height) x 3.0 cm (width).
• Weight: 100 g (including battery).

CONTROL

• There may be an insulating cap on the battery inside the flashlight from the factory. Remove it from the battery before first use.
• One click on any of the switches will turn the light on/off.
• Press and hold any switch to momentarily turn on. The flashlight will stay on while held and turn off again when the switch is released.
• Activating the strobe: With the flashlight on, press and hold any of the switches. After 0.5 seconds, the strobe will be activated and will illuminate while the switch is held.
• Switching between light outputs: switch the torch on, then press and hold one of the switches, pressing the other switch then switches between 1200 and 350 lumen modes.
• Locking the flashlight: When the light is off, press and hold both switches for 5 seconds. The light will then flash twice to indicate the flashlight lock status. To unlock, press both switches again simultaneously and hold them down for 1 second. This will reactivate the flashlight.
• Indication of the battery charge status: the indication LED is located on the side of the flashlight. The indication can be switched off/on with three quick presses of the button on the same side as the indication LED. The flashlight always indicates the battery charge level three seconds after switching on. Green indicates sufficient state of charge (100% - 85%), flashing green (85% - 50%), steady red (50% - 25%) and flashing red indicates critically low battery (25% - 1%). If the battery is low, the flashlight will automatically reduce power to 50 lumens over time.
• Charging the flashlight: flip off the rubber cap of the charging connector and plug it into a computer, USB AC adapter or USB car adapter (not included) using the included USB-C cable. Alternatively, any cell phone charger with a USB-C connector can be used to charge. The indicator LED on the side of the flashlight glows red while charging, and glows green when fully charged. Charging a fully discharged battery takes about 2 hours. The Li-ion battery used does not suffer from a memory effect, so the flashlight can be recharged at any time.

NOTICE

• Use only good quality rechargeable batteries to prevent damage to the flashlight, for example due to battery leakage.
• Observe all safety guidelines when using the flashlight on the weapon.
• Insert the batteries with the positive pole facing the head of the flashlight.
• If the flashlight flickers, glows at low power, or fails to light, it may be due to one of the following reasons:
  • The battery is dead - replace or recharge it.
  • The contacts inside the flashlight are dirty - clean them with a cotton ball dipped in alcohol.

PACKAGE CONTENTS

• Fenix GL19R flashlight
• Fenix ARB-L18-1100P battery
• USB-C charging cable
• GLOCK and 1913 Picatinny rail plates
• spare o-ring